Training catalogue does not show anything

whatif
Tue, 03/25/2014 - 11:33
Forums
Support
Hi I newly installed Opigno_LMS_1.7 and created class and course and course catagories also. But when I visit the training catalogue, I don't see anything. I expect there must be a class or course. There is no error message. What will be the possible cause of this error? Thanks in advance
Profile picture for user James Aparicio
James Aparicio
Tue, 03/25/2014 - 11:37

Hi whatif,

Hi whatif, This is normal behavior, the user that created the course is part of it. You only see courses that you are not part of inside the course catalogue. Best regards
whatif
Tue, 03/25/2014 - 11:53

Remove the 'Content:Nid(=0)" Filter criteria

Hi When I remove the 'Content:Nid(=0)" Filter criteria from the training catalogue view, the courses are shown in training catalogue. I think this 'Content:Nid(=0)" Filter criteria should be removed from this view.
Profile picture for user James Aparicio
James Aparicio
Tue, 03/25/2014 - 13:07

Hi whatif,

Hi whatif, If you think so, go ahead, that's the strength of Opigno, easy to customize to your needs. From a general purpose view,i think it makes sense to only show the courses you are not part of.